Are you looking for instructions on programming a universal remote to a Fluid TV? This guide is for you. The process involves entering the Fluid TV’s remote codes, which vary for each universal remote. This article summarizes the list of universal remote codes for Fluid TV with step-by-step instructions for programming a remote.
List of Remote Codes for Fluid TV
The Fluid TV codes can be 4 or 5 digits. The following codes are applicable for universal remotes, such as Comcast, DirecTV, GE, One For All, Philips, RCA, Spectrum, and U-verse.
| Code Format | Remote Codes for Fluid TV |
|---|---|
| 4 digit | 3907, 0911, 3559, 1304, 1104, 1204, 1027, 1025, 1026, 2431, 1025, 2421, 2964, 2401 |
| 5 digit | 14327, 14229, 12260, 14023, 13559, 12964, 13907 |
How to Program Universal Remote to Fluid TV With Code
Programming a universal remote to a Fluid TV is quick and involves entering a remote code. To get started, power on your Fluid TV with its physical button and follow these steps.
Manual Code Entry
1. Grab a universal remote and aim it towards the Fluid TV.
2. Hold the TV button on a universal remote. Following that, hold the Setup button.
3. While holding the Setup and TV buttons, enter the 4 or 5-digit remote code from the above table.
4. If the entered code has been accepted, the remote’s indicator light will flash two times.
5. Press the Power key on a universal remote and see if your Fluid TV turns off.
6. If it turns off, the remote has been programmed with the Fluid TV. If not, repeat steps 2-5 with a different remote code.
Auto Code Search
1. Long press the Setup and TV buttons on a universal remote.
2. Using the remote’s number button, press 9 9 1.
3. Repeatedly click and release the Power and Channel Up buttons on a universal remote. This will cause the universal remote to search for codes by itself.
4. Release both buttons when the Fluid TV turns off. Thus the remote pairing is successful.
How to Program Universal Remote to Fluid TV Without Code
1. Ensure your Fluid TV is turned on and keep the universal remote at a closer range to the TV.
2. Long press the TV and SEL/OK buttons on a universal remote for 5 seconds. The remote’s TV button will blink.
3. Click the Channel Up and Channel Down buttons on a remote continuously.
4. Then, click the Up and Down directional buttons one after another.
5. Stop clicking when your Fluid TV turns off. That’s it. You have finished pairing a universal remote with your Fluid TV.
Can’t program a universal remote to a Fluid TV in any of these ways? We have an alternate way if you have an Android mobile with a built-in IR blaster. If so, install the IR-based remote app on it from the Play Store and use it to control the Fluid TV without a remote.
